NT-600C WIDE BELT SANDER

NT-600C WIDE BELT SANDER

orCall 239-770-4474

Description

The NT-600C single combination head wide belt sander has a 24″ working width and comes standard with 25″ x 75″ belt and variable speed invisible seam feed mat. The combination head provides the benefit of sanding with a roller and platen in side a single head machine footprint. Features heavy steel frame design, digitally positioned elevation control with close to 6″ opening and independent start/stop controls for the feed and belt. The NT-600C single combination head wide belt sander has a 24″ working width and comes standard with 25″ x 75″ belt and variable speed invisible seam feed mat. The combination head provides the benefit of sanding with a roller and platen in side a single head machine footprint. Features heavy steel frame design, digitally positioned elevation control with close to 6″ opening and independent start/stop controls for the feed and belt.

Specifications

ManufacturerNorthtech Machine
ConditionNew
Machine hp11-1/4 HP
Voltage, frequency230/460 Volt 60Hz
Phase3 Phase
Amp requirement33/16.5 Amps
ConfigurationCombination
1st head15 HP 4'' Fluted Drum with Platen
Feed hp1 HP
Feed system24/1/2'' Feed Mat
Drive systemMotor / Gear Box / Variable Speed Clutch
Feed speed range15-35 FPM
Variable feed speedAdjustable Pulley
Elevation hp1/4 HP
Elevation styleDigital Readout
Elevation system4 Post Jack Screw
Approved electrical partsCE Approved Parts